Assembling Your Box

Continued from Building an Arcade-style Fight Stick

As I said, I won't cover much here, but I will go over some of the tools I used in my construction. A router and table saw will make the job much easier, but you can get by with just a drill, some specialized bits and a circular saw.

For the button holes, I used a 1 1/8" spade bit, purchased at the local hardware store for about $5. You can either lay your button layout sheet directly on the wood and drill through it, or you can just mark the centerpoints and save the layout for later use. The only things to remember with using the spade bit are to make sure you go in straight and be patient to avoid it getting bogged down or stuck.

For the joystick hole, I used a 2 1/4" hole saw attachment. Again, take your time lest you end up with a costly waste of wood due to a misplaced hole.

I recommend attaching your pieces using pegs made of dowel rod and wood glue, since that will be much sturdier (and nicer looking) than just a bunch of nails. If you're a master carpenter, go ahead and do a dovetail joint or anything else that will improve the strength of the box, since you'll be beating the hell out of it on a regular basis.

Page 1: Building an Arcade-style Fight Stick
Page 2: Assembling Your Box
Page 3: Pad Hacking
Page 4: Installing the Hardware
Page 5: Conclusions and Helpful Links

Posted in: arcade,DIY,fighter stick,pad hack,Street Fighter 4